Worktop fabrication in Notting Hill

Yes. Notting Hill is on the patch, and the postcodes we work here are W11. It is worked on our west London run, along with the rest of Kensington and Chelsea. Underground loading has a height restriction, and a van with an A-frame on it is taller than the driver remembers. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A semi has a side passage, and whether it is wide enough to carry a piece flat and turn it in at the back door is the first thing worth measuring. The other constraint is the hall: a piece has to come through the front door, round the newel at the foot of the stairs and through a doorway into the back kitchen, so we size the pieces to the tightest turn on that route before we nest anything, which sometimes means splitting a run that would otherwise have gone in whole. Every join over a gable, clear of every cut-out. Measure the turn at the foot of the area steps before you cut anything, because a 3m piece that clears the stair will still refuse the 90-degree swing at the bottom.

Almost the whole area is conservation area with single yellow and RBKC residents' bays, so a slab van gets a loading window rather than a parking space. Most houses are entered either up a raised front step or down external area steps into the lightwell, and that bottom landing is where slabs get stuck - it is often under 900mm deep with a right-angle turn straight into the kitchen door. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. Getting that wrong leaves a finished, machined piece that cannot reach the room, which is a remake rather than a trim. It is settled on the bench, not on site.

It is one of the three we do most here, behind worktop templating. Same template visit, same workshop, same installers either way. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. The drawing decides it, not the fitter. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.