Worktop templating in Notting Hill

Yes. Notting Hill is on the patch, and the postcodes we work here are W11. It is worked on our west London run, along with the rest of Kensington and Chelsea. Bay bookings are usually an hour or two, which is fine for unloading and no use at all as a place to leave the van for a day. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The rear room is generous with a chimney breast in one corner, so the run gains a return and two scribed ends whatever the plan drew. Alcoves either side of the breast are rarely the same width and rarely parallel, so each one is templated as its own piece with its own scribe. Recorded as it is, not as it was drawn. Measure the turn at the foot of the area steps before you cut anything, because a 3m piece that clears the stair will still refuse the 90-degree swing at the bottom.

Almost the whole area is conservation area with single yellow and RBKC residents' bays, so a slab van gets a loading window rather than a parking space. Most houses are entered either up a raised front step or down external area steps into the lightwell, and that bottom landing is where slabs get stuck - it is often under 900mm deep with a right-angle turn straight into the kitchen door. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop fabrication and worktop installation. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Join positions and vein direction are marked on the template drawing before it leaves site. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.