Worktop templating in Kensington

Yes. Kensington is on the patch, and the postcodes we work here are W8. It is worked on our west London run, along with the rest of Kensington and Chelsea. Where the bay sits some distance from the core, the carry across the car park is the longest leg of the day and gets boarded and lit. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Listing and conservation conditions apply to a good number of these, which constrains what can be altered around the kitchen rather than what goes on top of the units. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the template picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. Recorded as it is, not as it was drawn. Get the porter's lift dimensions and permitted hours in writing before you order, because a block that only allows deliveries 10am to 4pm turns a one-day install into two.

Mansion blocks are the constraint - porters control the goods entrance, works are usually restricted to weekday mid-morning to mid-afternoon, and the service lift is the only one you are allowed to use with materials. Measure the lift car diagonally including the ceiling height, because a 3m slab only goes in a small lift if it can be stood on edge and tilted, and many of these cars have low soffits. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. It goes on the drawing with the run dimensions.

It is one of the three we do most here, behind worktop design & quotation. Same template visit, same workshop, same installers either way. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn.

On a heavily veined stone the island and the run behind it are nested off the same area of slab so the movement relates across the room. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The stone carries the scribe because the wall cannot be persuaded, so back edges are cut oversize and eased in rather than dropped straight down. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. Fitted, fixed and level, then we come.