Splashbacks and upstands in Old Kent Road

Yes. Old Kent Road is on the patch, and the postcodes we work here are SE1, SE15. It is worked on our south east London run, along with the rest of Southwark. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Boxed soil stacks and ventilation ducts run behind the units, and the boxing depth changes between floor level and worktop height. The plasterboard is genuinely flat here, so a full-height splashback sits well and a slim upstand looks almost redundant, but the sockets are the problem, because they are set out to the developer's original kitchen and often land at odd heights or right on a joint line. The wall makes that decision, not the brochure. New-build handover kitchens here come with 20mm composite that is already chipped at the sink cutout, so replacement is usually about matching an existing sink and tap footprint.

The road is a red route with continuous traffic and no stopping, so every job is worked from the side streets, and new blocks add gated basement parking with limited headroom. Estate roads are often too tight for a long-wheelbase van to turn, so the carry starts a good deal further from the door than a map suggests. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. It decides panel size before anything is cut.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Housings and integrated appliances are set out for a 38mm laminate top, so dropping to 20mm or 30mm stone changes the clearances and needs checking before anything is cut. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Sockets final before template. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Siliconed to the worktop, never grouted.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. Scribed, dubbed out, or set proud. Pick one. Any socket you intend to move must be moved and re-plastered before templating, because a cut-out in the wrong place means a new piece of stone. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. Splashbacks are cut from the same slab run as the tops, so they have to be decided before fabrication, not after. Decided before fabrication, not after.