Worktop design and quotation in Peterborough Estate

Yes. Peterborough Estate is on the patch, and the postcodes we work here are SW6. It is worked on our west London run, along with the rest of Hammersmith and Fulham. A controlled parking zone means either a visitor permit sorted in advance or a suspended bay, and a suspension is applied for days ahead rather than on the morning. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Where the side return has been filled in, the old external wall is now an internal one and still carries its render, its gutter line and its old fixings. The kitchen is usually a long galley in a rear extension or side return, so the run lengths are the first thing we check against slab length, anything beyond roughly three metres either needs a join or a second slab, and that decision alone moves the material figure more than a few extra square metres would. That is what the itemised lines are for. The stock repeats, so keep the templates - the same joint layout that worked three doors down will almost certainly work again.

Uniform terraces with small front gardens, low walls and a gate, and permit bays that fill by evening, so morning slots are much easier. Side returns are almost always built out, so there is no alley left and the hall is the route - about 1m wide with the stair immediately on the right and a doorway into the kitchen at the end. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. We price the carry from what you tell us about the route, so photographs of the approach are worth more to us than a floor plan. It appears as its own line rather than buried in a rate.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop fabrication and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Itemised, so it can be compared honestly. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Material is the slab only, and it says so.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. Slab yield is worked out at quote stage, so if the layout forces a second slab you hear it before you commit rather than after. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. This is the item most often left out of a cheaper quote, and it comes back as a variation once the templater has been. Better on the quote than in a variation. Send us the run lengths, plus photos taken walking from the pavement through the hall to the kitchen so we can see the door widths and the stair turn. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. Material is quoted as a supply range and the labour lines separately, because an installed rate per square metre is not a real number. Every line has a reason next to it.