Kitchen worktops in Petts Wood

Yes. Very consistent stock from the inter-war estate: the original kitchen is a small rear room, and almost every job is a rear or side-return extension turning it into an L-shaped kitchen-diner with a peninsula. Because the houses repeat, the layouts repeat, typically a 3.6m rear run plus a 2.1m return. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. It goes on the job sheet for the fitting crew.

1930s mock-Tudor semi, 1930s detached, 1950s infill and chalet bungalow. A side alley and a back door mean most pieces go in whole, and it is the alley width rather than the front door that decides it. Access is usually the easy part here, as most of these have a side gate and a back door straight into the kitchen, so we carry down the side alley rather than through the house and keep the mess outside. That is the shape of the day.

Front drives on most houses and a side passage on the semis, but the side passages are narrow and often have a gas meter box or bin store in them, so slabs usually go in through the front. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. Finding it out on the morning costs the whole slot, because there is no second route to fall back on. That is what the morning is planned around.

Worktop templating, worktop installation and worktop design & quotation, in that order. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Comparing quotes only works when they itemise the same things, and this is where the differences usually hide. Itemised, so it can be compared honestly. The estate is under an Article 4 style design control on the frontages, so the constraint is scheduling around the builder finishing the extension rather than the fit itself.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The quote is written so it can be read by whoever is paying rather than only by whoever is standing in the kitchen. Nothing payable until template. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.