Worktop fabrication in Petts Wood

Yes. Petts Wood is on the patch, and the postcodes we work here are BR5. It is worked on our south east London run, along with the rest of Bromley. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. That is the last thing settled before dispatch. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A side alley and a back door mean most pieces go in whole, and it is the alley width rather than the front door that decides it. Where a full length can come down the side and in at the back, the nest follows the slab instead of the building. Settled on the drawing, cut once. The estate is under an Article 4 style design control on the frontages, so the constraint is scheduling around the builder finishing the extension rather than the fit itself.

Front drives on most houses and a side passage on the semis, but the side passages are narrow and often have a gas meter box or bin store in them, so slabs usually go in through the front. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. So the nesting is worked to the measured route first and to the slab second. Once the cut-outs are machined there is no going back on it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop design & quotation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch.

The return piece is the awkward one on a slab: short, full depth, and rarely nesting neatly against the long lengths, so yield rather than area is what moves the material figure. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Radiused, polished, and clear of the joins. The peninsula end detail needs deciding up front - square edge, mitred apron down the end, or a full waterfall - because a waterfall end has to be cut in sequence off the same part of the slab as the top. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.