Worktop fabrication in Pollards Hill

Yes. Pollards Hill is on the patch, and the postcodes we work here are SW16, CR4. It is worked on our south west London run, along with the rest of Merton. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. Pieces are loaded in reverse fitting order so the first thing off the van is the first thing that goes down. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Walls are dense block or in-situ concrete with a bonded plaster, so the bottom course of tiles brings plaster with it when the old top comes off. The kitchen is usually a small square or L-shaped room reached through a narrow entrance lobby and a standard internal doorway, so the limit on piece length is the turn out of the lobby, and short runs mean joins are often avoidable altogether if the layout is nested tightly. The bench proves it before the van moves. Closed-up hatches leave a shallow patch of new plasterboard right where the upstand lands, so fix through to the original blockwork rather than into the patch.

Cars park in courts and garage blocks set away from the front doors, so almost every job here involves a long carry along footpaths and through pedestrian alleys. Two-man handling with a slab trolley matters more than van proximity. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. So the nesting is worked to the measured route first and to the slab second. It is settled on the bench, not on site.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Nested for the job in front of us.

The return piece is the awkward one on a slab: short, full depth, and rarely nesting neatly against the long lengths, so yield rather than area is what moves the material figure. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. That is nested before any glass goes on the saw. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A lightweight stud partition will not carry a breakfast bar or a peninsula end, and stone finds that out faster than laminate ever did. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The stack boxing needs to be in its final form and the sink and hob on site before we machine, since a boxing that gets re-clad afterwards throws the notch out. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. Changing an appliance after the nest is set means recutting the piece, not adjusting it. The approved drawing is the instruction.