Worktop templating in Pollards Hill

Yes. Pollards Hill is on the patch, and the postcodes we work here are SW16, CR4. It is worked on our south west London run, along with the rest of Merton. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Many have been extended at the rear since being sold, so the kitchen is half original and half newer with a floor junction between the two. Concrete and dense block walls in ex-council stock cannot be chased back or packed out to suit, so the template takes the wall exactly as it is and the stone carries the scribe. Recorded as it is, not as it was drawn. Closed-up hatches leave a shallow patch of new plasterboard right where the upstand lands, so fix through to the original blockwork rather than into the patch.

Cars park in courts and garage blocks set away from the front doors, so almost every job here involves a long carry along footpaths and through pedestrian alleys. Two-man handling with a slab trolley matters more than van proximity. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. A template taken without walking the route produces a drawing that cuts beautifully and will not go in. The template records it along with everything else.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first.

Where the return runs into a wall that is out of square, the corner is templated as the angle it really is rather than as ninety degrees. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Taped internal angles in plasterboard belly at the corner, so the run picks up a few millimetres over the last 300mm and a plan-angle mitre will not close. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Plotted, not estimated. Every base unit fixed to the wall, packed and levelled, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.