Kitchen worktops in Portsoken

Yes. This ward holds a genuine concentration of long-standing City residential, and the estate flats have small, closed kitchens of roughly 2.0-2.6m with shallow original units and a fixed boiler cupboard. Work here is nearly always straightforward replacement in the existing footprint, cutting round a service duct and finishing with matching stone upstands rather than tiles. The practical answer is to check the fixture list before the date is offered, because a template slot lost to a road closure cannot be recovered that week. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. Handling is where these pieces get damaged.

City-owned postwar housing estate, 1960s-70s deck and corridor access block, modern infill flats and conversion above street-level retail. These are small blocks with a single stair, no lift, and a communal door that will not stay open on its own. The fitting itself is about squaring up to walls that look modern and are not: block or breeze walls with a skim that has been patched over decades, so we still dry-lay and scribe rather than trust the template edge. That is the shape of the day.

Estate blocks with controlled entry, communal stairs and a single lift per core, and the surrounding streets have market trading and heavy pedestrian flow around Middlesex Street on trading days. There is no meaningful visitor parking, so the van works a short loading window and the crew does a long push across a courtyard to the block door. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

Worktop replacement, worktop splashbacks & upstands and worktop installation, in that order. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Sockets final before template. Small kitchens, long carries, and a lift you cannot rely on - the labour cost here is all in getting the stone from the kerb to the flat.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. Carcasses have to be sound first. Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. This is the commonest reason a replacement turns out to need more than a straight swap. Found at template, not on fit day. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Same slab run as the tops. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.