Kitchen worktops in Pratts Bottom

Yes. Small hamlet stock with kitchens that are usually part of a rear extension or an old outbuilding brought into the house, so ceiling heights change mid-run and there is often a step down into the kitchen. Oil or LPG range cookers are more common here than in the suburbs. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it.

semi-rural detached, 1930s cottage, converted outbuilding and post-war bungalow. Doorways are low and narrow, which is a genuine constraint on piece length before anything else is considered. What costs time is the distance from where the van can park to the door, often down a long drive or across gravel, so we plan the carry with enough hands and board the route where it crosses gravel or lawn. That is the shape of the day.

Off the A21 down single-track lanes with passing places and blind bends, and driveways that turn sharply off the lane, so a long wheelbase van has to reverse in. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. Finding it out on the morning costs the whole slot, because there is no second route to fall back on. That is what the morning is planned around.

Worktop templating, worktop installation and worktop fabrication, in that order. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. Where there is a step down into an old outbuilding kitchen the cabinet plinths get packed, so we set datum from the units and not the floor.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Dry-lay first, always. A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.