Worktop replacement in Pratts Bottom

Yes. Pratts Bottom is on the patch, and the postcodes we work here are BR6. It is worked on our south east London run, along with the rest of Bromley. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Lime plaster over rubble moves in and out enough that a single long panel will show a gap somewhere along its length. Any island overhang past about 300mm will not carry weight on the carcass alone, so flat steel bar or brackets have to be let into the units first, and that is agreed at template stage, not on fit day. Units kept, surface changed, one day. Where there is a step down into an old outbuilding kitchen the cabinet plinths get packed, so we set datum from the units and not the floor.

Off the A21 down single-track lanes with passing places and blind bends, and driveways that turn sharply off the lane, so a long wheelbase van has to reverse in. Even an easy kerbside carry wants the pavement clear at the tail lift, because a three-metre piece on edge has a swing radius nobody expects until it is swinging. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop fabrication. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. The carcasses have to be sound, because stone is several times the weight of what is coming off. Sound carcasses or it does not go ahead. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. The units stay, the surface changes. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. This is the commonest reason a replacement turns out to need more than a straight swap. The laminate has been covering it up. Have a fitter or joiner fix and level the island units beforehand, and get the sink, taps, hob and any range on site before templating so we cut to the actual appliances. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Plumber either side of us.