Worktop design and quotation in Roxeth

Yes. Roxeth is on the patch, and the postcodes we work here are HA2. It is worked on our north west London run, along with the rest of Harrow. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. Nothing here is added after the fact. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cottage terraces have no hall to speak of and the front door opens almost straight into the room, which makes the carry easier and the protection harder. The kitchen is usually a long galley in a rear extension or side return, so the run lengths are the first thing we check against slab length, anything beyond roughly three metres either needs a join or a second slab, and that decision alone moves the material figure more than a few extra square metres would. You see it before you commit to anything. Low door heads and tight halls mean measuring the diagonal clearance at every doorway on the route, not just the kitchen entrance.

Narrow streets on the slope below the hill, kerbside parking only on the older cottages, and low door heads on the Victorian stock that make tilting a slab through a doorway awkward. The van gets close to the door and the stone comes off the tail lift onto a trolley, which is about the shortest carry we ever get. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. It appears as its own line rather than buried in a rate.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Nothing payable until we template. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Material is the slab only, and it says so.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Slab yield is worked out at quote stage, so if the layout forces a second slab you hear it before you commit rather than after. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Photographs are worth more than a plan here. Send us the run lengths, plus photos taken walking from the pavement through the hall to the kitchen so we can see the door widths and the stair turn. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. Material is quoted as a supply range and the labour lines separately, because an installed rate per square metre is not a real number. Every line has a reason next to it.