Worktop design and quotation in West Harrow

Yes. West Harrow is on the patch, and the postcodes we work here are HA1, HA2. It is worked on our north west London run, along with the rest of Harrow. A free-parking street with cars both sides can still leave the van forty metres away, and that distance is carry, not driving. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A side alley and a back door mean most pieces go in whole, and it is the alley width rather than the front door that decides it. These are typically two runs and a return, often into a rear extension, and the return piece is the awkward one, short, wide and rarely nesting well against the long pieces on the slab, so slab yield rather than total area is what pushes the material line up. Priced from the building, not from a rate card. The shared side alley is the deciding factor on these terraces, so confirm the gate width and whether the neighbour's fence can be dropped before promising a single-piece top.

Terraced streets with a few dropped kerbs and mostly free but crowded parking, and side alleys of around 750mm shared with the neighbour, which usually works for a slab on edge if the gate is removable. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. That is why the fitting line on a quote reflects manpower and time rather than square metres. It appears as its own line rather than buried in a rate.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Nothing payable until we template. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Material is the slab only, and it says so.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. This is the item most often left out of a cheaper quote, and it comes back as a variation once the templater has been. Photographs are worth more than a plan here. Send the extension drawing or the unit layout with the actual appliance model numbers, since cut-out sizes come from the appliance, not the cabinet. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. Material is quoted as a supply range and the labour lines separately, because an installed rate per square metre is not a real number. Nothing payable until template.