Worktop templating in Seething Wells

Yes. Seething Wells is on the patch, and the postcodes we work here are KT6. It is worked on our south west London run, along with the rest of Kingston upon Thames. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. The template plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. Two to three hours, once the units are in. Conversion flats have tall ceilings but narrow original door openings, so the width of a slab on the trolley is what catches you out, not the height.

The river frontage limits approach to one road, and the converted works have gated courtyards, shared stairs and only a handful of visitor bays, so unloading is often 30 to 40 metres from the flat door. The barrier, the entry code and the estate rules decide when a van can get near the door, and none of that is negotiable on the day. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop replacement. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

An intruding steel column, a brick pier or a downstand breaks a run that would otherwise have been one clean piece. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.