Worktop installation in Shooters Hill

Yes. Shooters Hill is on the patch, and the postcodes we work here are SE18. It is worked on our south east London run, along with the rest of Greenwich. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. We aim for the first slot of the day where parking is tight, because that is when the street is emptiest. It is why the arrival time is what it is. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Original joinery is deep and stands proud of the plaster, so the run is plotted to the units rather than to the wall behind them. What costs time is the distance from where the van can park to the door, often down a long drive or across gravel, so we plan the carry with enough hands and board the route where it crosses gravel or lawn. The slow parts are slow for a reason. Plenty of room inside, but the approach is uphill and often over gravel, bring a proper A-frame rather than trusting a barrow.

The gradient defines everything: long sloping drives, houses set well above the road behind steps, and a fast main road up the hill with nowhere safe to unload on the bends. Even an easy kerbside carry wants the pavement clear at the tail lift, because a three-metre piece on edge has a swing radius nobody expects until it is swinging. Finding it out on the morning costs the whole slot, because there is no second route to fall back on. None of it is worked out on the doorstep.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop design & quotation and worktop fabrication. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. One visit, with the sink and hob seated and sealed before we leave. One visit, done properly. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. Joins are pulled with suction clamps and finished flush, then colour-matched, which is the last thing done rather than the first. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Give us the hardest, shortest approach to the door you can, clear of parked cars, and warn us of any soft ground, steps or gravel on the route. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. A half-day of access is not a fitting day, and it is better to say so at booking than to find out at eleven. Access for the whole slot, or a different day.