Worktop installation in Eltham

Yes. Eltham is on the patch, and the postcodes we work here are SE9. It is worked on our south east London run, along with the rest of Greenwich. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. The fitting slot is set around it, which is why we ask about it when the date is booked and not before we leave the yard. The day is built around that window. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Where the side return has been filled in, the old external wall is now an internal one and still carries its render, its gutter line and its old fixings. The day is planned backwards from the hall. That is the shape of the day. The classic Eltham job is templating a new extension where the old back wall has come out, get the steel-supported opening measured properly, it is rarely square to the new build.

Suburban streets with front drives and dropped kerbs on most roads, so the van usually gets within a few metres of the door; the stretches around the High Street and the station are the exception. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop design & quotation and worktop templating. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The fitting day is scheduled to suit that rather than to suit the diary. The prep list is not optional. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. One visit, with the sink and hob seated and sealed before we leave. Sealed before we leave.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Exposed structure means the back edge is not a straight line at all, and a scribe of fifteen or twenty millimetres across a run is normal. On the day it means dry-laying, marking, and cutting the scribe on site before anything is bonded. Dry-lay, mark, cut, then bond. Clear the full hall and stairs route of furniture, bikes, coats and stair-gates, and keep the front door propped and unobstructed for the carry. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The fitting day is arranged with whoever can actually give us access for the whole slot. Protection goes down first.