Worktop installation in New Eltham

Yes. New Eltham is on the patch, and the postcodes we work here are SE9. It is worked on our south east London run, along with the rest of Greenwich. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. We aim for the first slot of the day where parking is tight, because that is when the street is emptiest. We would rather ask than guess. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Where the roof has been converted there is usually a steel over the kitchen that went in after the walls, and the run beneath it is worth checking for square. The fitting itself is slower than the carry: original plaster on the party wall and around the old chimney breast is rarely square to the run, so back scribes get cut on site, and where a return wraps into a breast recess we template that shoulder tight and ease it in. Walked, measured, protected, then lifted. Low sills under the sink window are common in the bungalows, check upstand height at template stage or you'll be cutting on site.

Good: nearly every house has a drive or hardstanding, the roads are wide and turning space is easy, with pinch points only around the station and the shops. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. The fitting day is planned backwards from that point, before anything comes off the van. That is what the morning is planned around.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop replacement and worktop design & quotation. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The fitting day is scheduled to suit that rather than to suit the diary. Sealed before we leave. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. One visit, with the sink and hob seated and sealed before we leave. One visit, done properly.

Three runs means two internal corners, and each corner is a decision about mitre or butt joint before anything is nested. On the day that means dry-laying the whole layout first and only then pulling and bonding the joins. Nothing is bonded until the whole run sits flat. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Sill height gets settled with the template on site, because it is one of the few dimensions nobody has measured before we arrive. The back edge is eased in progressively rather than offered up once and forced. Dry-lay, mark, cut, then bond. Unlock and clear the side gate and back door, and move bins, planters and washing lines out of the alley run. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. Floors and units are protected before anything comes through the door, communal or otherwise. Access for the whole slot, or a different day.