Splashbacks and upstands in New Eltham

Yes. New Eltham is on the patch, and the postcodes we work here are SE9. It is worked on our south east London run, along with the rest of Greenwich. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. Panels come off the van in one trip where possible, since a tall piece handled repeatedly is a piece asking to be chipped. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Everything on one level means no stairs, no landings and no turns, which is about the easiest carry there is in domestic work. That leaves a ragged band right where the upstand has to sit, which is fine for a 100mm upstand that covers it, but a full-height splashback needs the wall made good first or it will rock on the high spots. The wall makes that decision, not the brochure. Low sills under the sink window are common in the bungalows, check upstand height at template stage or you'll be cutting on site.

Good: nearly every house has a drive or hardstanding, the roads are wide and turning space is easy, with pinch points only around the station and the shops. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. Joint positions follow from that.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop installation, worktop replacement and worktop design & quotation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Siliconed to the worktop, never grouted. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Sockets final before template.

A U shape uses more linear metres than people expect, and the two returns rarely nest together, so a second slab is a genuine possibility. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Corners get their own pieces. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a run finishes into a reveal, the depth of that reveal is taken at worktop height and nowhere else. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. The old tiling must be off and the wall made good and dry before templating, not on fitting day. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. Splashbacks are cut from the same slab run as the tops, so they have to be decided before fabrication, not after. Decided before fabrication, not after.