Worktop fabrication in Sloane Square

Yes. Sloane Square is on the patch, and the postcodes we work here are SW1W, SW3. It is worked on our west London run, along with the rest of Kensington and Chelsea. Bay bookings are usually an hour or two, which is fine for unloading and no use at all as a place to leave the van for a day. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. That is the last thing settled before dispatch. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Edwardian terraces are wider and taller than the Victorian houses next to them, so the kitchen usually takes a full-width rear room rather than a narrow outrigger. The galley run down a side-return usually measures longer than a slab will give us, so a join is designed in from the start and nested to land over a cabinet gable rather than wherever the material happens to run out. Settled on the drawing, cut once. Landlord consent and the lease decide what you are allowed to change, so confirm it is a straight replacement before templating anything that moves a service.

Porters, sign-in books, lift protection and a works-hours window that typically runs weekday daytime only, with no weekend working permitted under the lease. Sloane Street and the square itself have short loading windows and heavy enforcement, so unloading is normally into the block's side or rear service door on a timed slot. Sign-in at the gate, a permit on the dash and a named contact are usually wanted before anything comes off the van. So the nesting is worked to the measured route first and to the slab second. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Pieces are dry-assembled and checked on the bench before anything is loaded. Proven on the bench before dispatch.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. The drawing decides it, not the fitter. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Access in a tenanted flat depends on the tenant, so the template and fitting dates are agreed with whoever actually holds the keys. Sink and hob are dry-fitted on the bench before dispatch, whoever supplied them. Dry-assembled before it leaves.