Worktop replacement in South Wimbledon

Yes. South Wimbledon is on the patch, and the postcodes we work here are SW19. It is worked on our south west London run, along with the rest of Merton. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. The waste run is planned, not improvised. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A small room puts the sink, hob and tap cut-outs close together on one short length, and the bridge of stone left between them decides whether it can be cut in one piece. In most Victorian terraces the kitchen sits in the back addition, so you get a narrow galley with one outside wall and nothing square to work off. Sound carcasses are the one condition. Old walls out here bow badly over a 3m run, so scribe generously and expect to take 10 to 15mm off the back edge rather than trusting the plaster line.

Front doors open more or less straight onto the pavement with no front garden to stage on, and Merton High Street plus the tram line limit where a van can sit. Hallways are around 900mm wide with a dogleg at the stairs, so the slab is turned on edge before the first corner. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. With no room to turn, the old top gets cut up in the kitchen instead, which is dusty work and needs the room emptied first. The strip-out is planned around it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop splashbacks & upstands and worktop installation. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. Carcasses have to be sound first. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Legs bottoming out on hard concrete or an uneven screed mean the tops of the carcasses are not one plane, and that is picked up at template rather than on fitting day. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. Found at template, not on fit day. Have a plumber booked to disconnect the sink, tap and waste first thing and reconnect after we have gone, and clear the hallway and stairs completely so we can carry slabs through the house. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. A plumber disconnects before we arrive and reconnects after we leave, and that is worth booking early. Units kept, surface changed.