Splashbacks and upstands in St Katharine Docks

Yes. St Katharine Docks is on the patch, and the postcodes we work here are E1W. It is worked on our east London run, along with the rest of Tower Hamlets. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Walls are dense in-situ concrete or blockwork with a thin skim, which will not be chased back and will not take a plasterboard fixing. Dense concrete takes adhesive better than fixings, which actually suits a large bonded panel. Cut from the same slab run as the tops. Barrier and dwell-time limits mean the slab comes off the van in one go, so the crew and the route need to be sorted before it arrives.

The estate is privately managed with barrier-controlled vehicle entry, so the van needs booking in and a time-limited pass to reach the block door. Once inside it is a flat, level route across paved quayside, but lifts are small 1970s cars and some blocks route deliveries through a basement service corridor. Where the parking court sits behind the block the carry crosses open ground and gets boarded, because loaded trolleys and block paving do not agree. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. Joint positions follow from that.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Sockets final before template. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Siliconed to the worktop, never grouted.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. Make the wall good first, or accept the detail. Any surface trunking or conduit has to be rerouted or accepted and boxed before templating, because the stone cannot be scribed around a live conduit on site. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. Full-height panels need the wall made good first, which is another trade and another timescale. Same slab run as the tops.