Splashbacks and upstands in St Paul's Cray

Yes. St Paul's Cray is on the patch, and the postcodes we work here are BR5. It is worked on our south east London run, along with the rest of Bromley. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. Upstands travel in a crate and can wait on the van, which gives some flexibility a full-height panel does not. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The kitchen is a small square room off a narrow entrance lobby, and the turn out of that lobby is the real limit on piece length. The rear kitchen wall in ex-council flats and maisonettes is commonly dense in-situ concrete or blockwork with a thin skim, which means mechanical fixings are hard work and the splashback is held on adhesive rather than screwed. Decided before fabrication starts. Existing base units on this stock are often out of level by 10mm or more, so we shim and check against a datum before setting down, otherwise the joint opens up.

Wide estate roads and space to park, but long shared footpaths from the road to individual front doors and a lot of properties with only a pedestrian gate. Garden routes carry their own hazards: a drain cover, a step up to a patio, wet decking, or a lawn that will not take a loaded trolley. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. That is agreed at template, not on fitting day.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Siliconed to the worktop, never grouted. Quartz suits let property well: no sealing, no annual maintenance, and nothing an incoming tenant has to be told to look after. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Same batch, same run, same day.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A junction between an original floor and a later extension slab is almost never at the same level, so units carrying a run across it need packing first. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. Any surface trunking or conduit has to be rerouted or accepted and boxed before templating, because the stone cannot be scribed around a live conduit on site. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. Full-height panels need the wall made good first, which is another trade and another timescale. Decided before fabrication, not after.