Splashbacks and upstands in Stamford Hill

Yes. Stamford Hill is on the patch, and the postcodes we work here are N16. It is worked on our east London run, along with the rest of Hackney. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. Upstands travel in a crate and can wait on the van, which gives some flexibility a full-height panel does not. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Half-landings mean the back of the house sits at a slightly different level from the front, and a knocked-through kitchen crosses that line. Lath-and-plaster on the party wall and the chimney breast returns almost never runs true, so a 100mm upstand bedded on silicone is the honest answer here, it rides the bow and hides the junction the worktop can never close on its own. The wall makes that decision, not the brochure. Very long runs and heavy daily use push the specification here, so thicker material, fewer joins and a hard-wearing finish matter more than they do anywhere else in the borough.

Stamford Hill itself is on the A10 red route with no stopping, and the residential streets are permit-only with parking pressure all day. Most houses have front paths and side access though, which makes the carry easier than the parking situation suggests. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. Joint positions follow from that.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop fabrication, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where an annexe has been built or converted, its floor and its walls are newer than the main house and behave differently under the same run. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day. Extended households run kitchens hard, and that pushes the specification towards granite or sintered stone rather than a light quartz. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Siliconed to the worktop, never grouted.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. Scribed, dubbed out, or set proud. Pick one. The chimney breast recess must be replastered and fully dry, and the hob and extractor positions fixed, before anyone templates a full-height piece into it. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. Full-height panels need the wall made good first, which is another trade and another timescale. The wall has to be ready.