Worktop templating in Stoke Newington

Yes. Stoke Newington is on the patch, and the postcodes we work here are N16. It is worked on our east London run, along with the rest of Hackney. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A long piece has to come through the front door, down the hall, round the newel post and through a doorway with a step down into the addition. Alcoves either side of the breast are rarely the same width and rarely parallel, so each one is templated as its own piece with its own scribe. Two to three hours, once the units are in. Long side-return runs usually need a join, so place it at a cabinet break and batch-match, because an island and a 4m run cut from different blocks will not look right in this much daylight.

Church Street is narrow, busy and loading-restricted, and the surrounding streets are permit-only with several filtered junctions. Terraces are set behind small front gardens with a few steps, and halls run straight through to the rear, which helps the carry considerably. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop installation and worktop design & quotation. A licensed shared house has fire-door and escape-route rules that decide how and when stone can be carried through the common parts. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

Seating overhangs past roughly 300mm will not carry on the carcass alone, so flat steel bar or a plywood substrate has to be built into the units first. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Measured at worktop height, nowhere else. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.