Worktop replacement in Stoke Newington

Yes. Stoke Newington is on the patch, and the postcodes we work here are N16. It is worked on our east London run, along with the rest of Hackney. Without a bay the van ends up on a single yellow with a crew member watching it, which takes a pair of hands off the carry. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. Old tops out and new stone in, both through the same gap. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The back addition is a narrow two-storey outrigger with a single external wall, and the kitchen galley runs the length of it. Lath-and-plaster and bowed brickwork mean we template for scribes rather than straight cuts, and each piece is offered up and eased in rather than dropped straight down. What is under the old top is the real question. Long side-return runs usually need a join, so place it at a cabinet break and batch-match, because an island and a 4m run cut from different blocks will not look right in this much daylight.

Church Street is narrow, busy and loading-restricted, and the surrounding streets are permit-only with several filtered junctions. Terraces are set behind small front gardens with a few steps, and halls run straight through to the rear, which helps the carry considerably. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop design & quotation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Where a single building holds several small kitchens, the work arrives as one job rather than four, and it should be cut off the same slab run so the batches genuinely match. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project. Small kitchens in a shared house are all short runs and tight cut-out spacing, which is more bench work per square metre than one large kitchen would be. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. The units stay, the surface changes. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. This is the commonest reason a replacement turns out to need more than a straight swap. The laminate has been covering it up. Have a plumber booked to disconnect the sink, tap and waste first thing and reconnect after we have gone, and clear the hallway and stairs completely so we can carry slabs through the house. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Plumber either side of us.