Worktop templating in Stonebridge

Yes. Stonebridge is on the patch, and the postcodes we work here are NW10. It is worked on our north west London run, along with the rest of Brent. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

There is nearly always a boxed service duct or a stopcock cupboard in one corner, and it eats into the usable depth of the run. Unit height is the other issue: legs sit on an uneven screed or hard concrete with no give, so the template reads the top of every carcass rather than assuming they share a height. No stone is ever cut from a plan. Stair carries in walk-up blocks decide the cut list, so template with the turn on the half-landing in mind and split at a sink or hob cut-out where possible.

Estate roads with parking courts and controlled entry, and a lot of the flats are first or second floor with a communal stair rather than a lift, which caps the sensible piece length. A walk-up with winders at every half-landing means the piece is rested and re-gripped on the way, so the crew size goes up before the piece size comes down. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. A worktop replacement between tenancies is a single-day job by design, because the flat is not earning while it is empty. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. Units fitted, fixed and level first. Where kitchens turn over between tenancies the priority is a surface that survives a decade of being treated as a chopping board. Two to three hours on site, with the sink, tap and hob physically present. The room as it is, not as it was drawn.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Every base unit fixed to the wall, packed and levelled, and any dry-lining or patching completed - the template reads the wall face it is given, so that has to be the finished face. Managed stock usually comes with its own rules about working hours, waste, and who is allowed on site. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.