Worktop installation in Stratford

Yes. Stratford is on the patch, and the postcodes we work here are E15. It is worked on our east London run, along with the rest of Newham. The practical answer is to check the fixture list before the date is offered, because a template slot lost to a road closure cannot be recovered that week. A van that has to move mid-fit costs the best part of an hour and takes a man off the tools to do it. The day is built around that window. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Lease conditions and the other flats in the building decide when noisy work can happen, so the fitting day has a start and a finish that are not ours to set. The day is planned backwards from the hall. Walked, measured, protected, then lifted. The recurring job is stripping out a builder-spec top in an occupied new flat, so dust control and a same-day sink swap matter as much as the stone.

Around the centre almost everything is a managed development with basement loading bays, booked goods lifts and marshalled service yards, and events at the nearby venues bring road closures and event-day parking restrictions. The Victorian streets are CPZ-controlled with narrow bays and no forecourt. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. Finding it out on the morning costs the whole slot, because there is no second route to fall back on. That is what the morning is planned around.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. One visit, with the sink and hob seated and sealed before we leave. Sealed before we leave. Handover-spec kitchens are square, plumb and predictable, which means the join count is honest and driven by run length rather than by the building. Where the window is fixed there is no second day to fall back on, so the prep list matters more than usual. One visit, done properly.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. A layout that has been packed and levelled run by run instead of to one datum shows as a step where two pieces meet. Dry-lay first, always. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

The stone carries the scribe because the wall cannot be persuaded, so back edges are cut oversize and eased in rather than dropped straight down. Rushing that is what leaves a gap you look at every morning for fifteen years. Eased in, never forced. Clear the full hall and stairs route of furniture, bikes, coats and stair-gates, and keep the front door propped and unobstructed for the carry. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. The fitting day is arranged with whoever can actually give us access for the whole slot. Protection goes down first.