Worktop templating in Stratford

Yes. Stratford is on the patch, and the postcodes we work here are E15. It is worked on our east London run, along with the rest of Newham. Where an event closes the road entirely, the van cannot be moved once it is in, which is a different problem from not being able to park at all. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A villa cut into flats leaves kitchens in rooms that were never kitchens, with services run to wherever they could physically be made to reach. The template plots the bow along the back of the run, which is why a tape reading taken beforehand never matches. No stone is ever cut from a plan. The recurring job is stripping out a builder-spec top in an occupied new flat, so dust control and a same-day sink swap matter as much as the stone.

Around the centre almost everything is a managed development with basement loading bays, booked goods lifts and marshalled service yards, and events at the nearby venues bring road closures and event-day parking restrictions. The Victorian streets are CPZ-controlled with narrow bays and no forecourt. Piece length is set by the internal diagonal of the lift car, not by the length of the slab. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. That is part of what the visit is for.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Developer-fitted kitchens come with thin cam-lock carcasses, which are fine under laminate and want bracing before stone goes on them. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Two to three hours on site, with the sink, tap and hob physically present. Units fitted, fixed and level first.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. The template happens when the units are in, fixed and level, whoever is fitting them. No stone is cut from a plan.