Worktop replacement in Streatham Vale

Yes. Streatham Vale is on the patch, and the postcodes we work here are SW16. It is worked on our south London run, along with the rest of Lambeth. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. We stage the strip-out so the old tops leave in one trip rather than trickling out across the afternoon. It is a full day at the kerb, not a delivery. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The kitchen is usually a rear room extended into the garden, with the original external wall now standing inside the run. The junction between the old floor and the extension floor is where a run crossing it needs packing before stone goes on. What is under the old top is the real question. These houses almost all still have the original back-boiler flue or a boxed vertical duct in the kitchen corner, so allow for a notched return leg as a matter of course.

Streets are quieter and largely uncontrolled compared with the Streatham high road, and many houses have hardstanding or a dropped kerb. The railway line and the limited crossings mean the approach route needs checking, and side alleys are around 780mm at the gate. A side gate and a back door mean the stone never goes through the house at all, which keeps the dust and most of the risk outside. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

It is one of the three we do most here, behind worktop installation. Same template visit, same workshop, same installers either way. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project.

Where the return runs into a wall that is out of square, the corner is templated as the angle it really is rather than as ninety degrees. Going from a 38mm laminate to 20mm or 30mm stone drops the surface, which shows against tiles, a window board and any freestanding appliance. Height change is checked before we cut. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. This is the commonest reason a replacement turns out to need more than a straight swap. Found at template, not on fit day. Unlock the side gate and clear the alley of bins, bikes and pots, and arrange a plumber for the sink and an electrician if the hob is hard-wired. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. A plumber disconnects before we arrive and reconnects after we leave, and that is worth booking early. Sound carcasses are the condition.