Worktop replacement in Streatham

Yes. Streatham is on the patch, and the postcodes we work here are SW16. It is worked on our south London run, along with the rest of Lambeth. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. The waste run is planned, not improvised. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Working hours are constrained by the business underneath, so noisy work has a window rather than a day. Chipboard carcasses under the sink swollen from a slow leak will not take stone and get replaced before fit day. Units kept, surface changed, one day. Above-shop kitchens here sit on old timber floors that slope towards the front of the building, so level off the units and pack rather than following the floor.

The high road is a red route with bus lanes and constant traffic, and above-shop flats are reached through a shared door and a straight steep stair with no landing to rest on. Residential side streets are permit-controlled but usually workable outside peak hours. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop splashbacks & upstands and worktop installation. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project.

Where the return runs into a wall that is out of square, the corner is templated as the angle it really is rather than as ninety degrees. Old laminate has often been holding a run square for years, and taking it off shows what the units were really doing. Height change is checked before we cut. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. We would rather find it at template than on the morning, which is why the templater looks behind the units. The laminate has been covering it up. Empty the base units completely and have a plumber disconnect the sink, tap and any washing machine plumbed in under the worktop before we arrive. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Plumber either side of us.