Worktop templating in Streatham

Yes. Streatham is on the patch, and the postcodes we work here are SW16. It is worked on our south London run, along with the rest of Lambeth. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The structure below is commercial, so the floor is often timber over a shop ceiling and the load path under an island is worth thinking about. The scribe at worktop height differs from the one at plinth level, and only the worktop line matters. Two to three hours, once the units are in. Above-shop kitchens here sit on old timber floors that slope towards the front of the building, so level off the units and pack rather than following the floor.

The high road is a red route with bus lanes and constant traffic, and above-shop flats are reached through a shared door and a straight steep stair with no landing to rest on. Residential side streets are permit-controlled but usually workable outside peak hours. Communal stairs get boarded and the handrail padded, and we walk the route with a tape before the first piece leaves the van. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. The template records it along with everything else.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order.

An L can be mitred at the corner for a continuous look or butt-jointed over the gable, and the two are different money and different risk. The template records every angle in that shape as it actually is rather than as the plan drew it. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. That is why the visit takes two or three hours. Units fixed, packed level and pushed as far back as the leaning wall allows, walls made good to final thickness with tiling left until after the worktop, and the sink, tap and hob on site so cut-outs are set from the real items. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. Fitted, fixed and level, then we come.