Kitchen worktops in Sundridge Park

Yes. Houses around the golf course and station tend to be deep-plan with the kitchen in a rear addition, so the common job is a galley run down one side plus a short return under a window looking onto a long garden. Utility rooms are often carved out of the old outhouse or side passage. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause.

Edwardian villa, 1920s detached, 1930s semi and post-war infill detached. The classic arrangement is the original back room with a later extension bolted onto it, so the kitchen is two ages of building in one room. The kitchen is normally the original back room with a later side-return or rear extension bolted on, and that helps us: most pieces can go down the side alley and in through the back door in one length, so we can avoid joins that a front-door route would force. What is under the old top is the real question.

Sloping driveways and mature front hedges are the main issue, plus a lot of the older houses have a step up to a side gate that is too narrow for a slab, so it becomes a front-door carry with a turn at the bottom of the stairs. The side passage is the measurement that matters, because a piece has to be carried flat down it and then turned in at the back door, and the turn is always tighter than the passage. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. It sets what the day actually looks like.

Worktop templating, worktop installation and worktop replacement, in that order. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first. Original rear additions here are rarely square, so the template has to pick up a taper across the run rather than assume parallel walls.

Two runs meeting at an internal corner is the most common shape we fit, and the corner is where the decisions are. The existing layout is being kept, so the question is whether the old carcasses will take stone in that shape without more support. The units stay, the surface changes. Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.