Worktop design and quotation in Sutton

Yes. Sutton is on the patch, and the postcodes we work here are SM1, SM2. It is worked on our south London run, along with the rest of Sutton. A red route means no stopping, and no stopping means exactly that, so the stone comes in from a side street or from a bay behind the property. Where a bay suspension or a permit is needed, that is a real cost and it goes on the quote instead of appearing later. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A small room puts the sink, hob and tap cut-outs close together on one short length, and the bridge of stone left between them decides whether it can be cut in one piece. The kitchen is usually a long galley in a rear extension or side return, so the run lengths are the first thing we check against slab length, anything beyond roughly three metres either needs a join or a second slab, and that decision alone moves the material figure more than a few extra square metres would. That is what the itemised lines are for. The pedestrian zone hours dictate everything here, so town-centre fits get booked for early morning and the van has to be clear before the restriction starts.

Pedestrianised High Street with strict vehicle access hours, controlled parking on the surrounding streets, and apartment blocks with booked lifts and loading bays. A car that takes 2.4m on the diagonal will not take a three-metre worktop however it is stood, and there is no trimming it on the landing. We price the carry from what you tell us about the route, so photographs of the approach are worth more to us than a floor plan. Nothing about it gets estimated after the fact.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Housings and integrated appliances are set out for a 38mm laminate top, so dropping to 20mm or 30mm stone changes the clearances and needs checking before anything is cut. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Itemised, so it can be compared honestly. Upgrading a builder-finish kitchen is mostly a swap, so the cost sits in the material choice rather than in the shape of the room. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Material is the slab only, and it says so.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. It is fabrication time rather than material, so it appears on the fabrication line and not in the square metre figure. Better on the quote than in a variation. Send us the run lengths, plus photos taken walking from the pavement through the hall to the kitchen so we can see the door widths and the stair turn. A street with houses in single occupation next to the same houses cut into flats produces two completely different jobs from the same elevation. Nothing is payable until we template, so a quote can sit while consents and decisions catch up. Written to be read by whoever is paying.