Kitchen worktops in Sutton

Yes. Around the High Street it is mostly flats and small terraces, with kitchens of 2.4-3m in a rear addition or a corner of an open-plan living space. New blocks come with integrated appliances already fitted and only the tops replaced or upgraded on handover. Where the frontage is a clearway the unload happens away from the door and the carry gets longer, which is a crew and time question rather than a stone one. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. Old tops out and new stone in, both through the same gap.

Victorian terrace, Edwardian terrace, 1960s block and new-build apartments. Floors are suspended timber over a shallow void and have moved, so the units are packed and levelled before anything is set on them. Lath-and-plaster and bowed brickwork mean we template for scribes rather than straight cuts, and each piece is offered up and eased in rather than dropped straight down. Units kept, surface changed, one day.

Pedestrianised High Street with strict vehicle access hours, controlled parking on the surrounding streets, and apartment blocks with booked lifts and loading bays. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. The strip-out is planned around it.

Worktop replacement, worktop templating and worktop splashbacks & upstands, in that order. Developer-fitted kitchens come with thin cam-lock carcasses, which are fine under laminate and want bracing before stone goes on them. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. A day, not a project. The pedestrian zone hours dictate everything here, so town-centre fits get booked for early morning and the van has to be clear before the restriction starts.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Long runs almost never take a single panel, so the joint positions want agreeing before anything is templated. Joint placement is a decision, not an accident. A run can measure dead right at both ends and still belly out in the middle, which only appears once the template plots the intermediate points. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. Found at template, not on fit day. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.