Kitchen worktops in Benhilton

Yes. Older stock on the hill north of the town centre with narrow rear kitchens in back additions, typically 2.6m of run with a boiler cupboard eating one corner. Some of the larger villas have been opened up into full kitchen-diners with a peninsula. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. Old tops out and new stone in, both through the same gap.

Victorian terrace, Victorian villa, inter-war semi and post-war flats. The rear wall is usually a single brick thick and has been rendered, patched and re-rendered, so it bows in and out along the length of the run. Lath-and-plaster on the party wall and the chimney breast returns almost never runs true, so a 100mm upstand bedded on silicone is the honest answer here, it rides the bow and hides the junction the worktop can never close on its own. The wall makes that decision, not the brochure.

Streets climb steeply from the town centre with parking on both sides and no off-street space on the terraces, so the carry is up a hill and then in through the front door. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. It decides panel size before anything is cut.

Worktop replacement, worktop templating and worktop splashbacks & upstands, in that order. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first. Boiler cupboards in the corner of these back additions are usually staying put, so we template around them and put the joint at the cupboard return.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Old laminate has often been holding a run square for years, and taking it off shows what the units were really doing. The units stay, the surface changes. A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. Make the wall good first, or accept the detail. Material runs from £110 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines rather than rolled into one figure.

Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come. Tell us the building when you book and the lift, the stair turn and any freeholder notice get built into the day rather than found on it.