Worktop design and quotation in Benhilton

Yes. Benhilton is on the patch, and the postcodes we work here are SM1. It is worked on our south London run, along with the rest of Sutton. Gravel and block paving both look like hard standing and neither takes a loaded trolley, so the run from tail lift to door gets boarded. Tell us at enquiry stage and it is priced properly, because a crew stood waiting is the most expensive thing on any job. It is one line among the others, and it is honest. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A bay-fronted terrace has a long hall running past the stairs to the kitchen, so the hall turn caps the piece length before the run length does. The kitchen is usually a long galley in a rear extension or side return, so the run lengths are the first thing we check against slab length, anything beyond roughly three metres either needs a join or a second slab, and that decision alone moves the material figure more than a few extra square metres would. Priced from the building, not from a rate card. Boiler cupboards in the corner of these back additions are usually staying put, so we template around them and put the joint at the cupboard return.

Streets climb steeply from the town centre with parking on both sides and no off-street space on the terraces, so the carry is up a hill and then in through the front door. Carrying through the house means protecting the whole route first: floor boarded, banister padded, and the front door held open on a wedge rather than by hand. An access-driven join is priced like any other join, and people are always surprised to see one on a dead straight run. It appears as its own line rather than buried in a rate.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop splashbacks & upstands. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. The junction between the original room and the extension is the point to watch, because the two floors rarely sit at the same height. Everything is itemised: material, template, fabrication, fitting, each cut-out and each metre of upstand. Itemised, so it can be compared honestly. Extension kitchens are usually specified long before they are buildable, so the run lengths on the drawing and the run lengths in the room are different numbers. That changes what the quote should be compared against, because the shape of the job is not the same as a single family kitchen. Material is the slab only, and it says so.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. Each run is priced on its own line against the supply rate, with the join count and the reason for each join stated. Shape first, area second. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A notch around a boxed stack is machined with a radius at the internal corner, because a square inside corner there is exactly where a top will crack. This is the item most often left out of a cheaper quote, and it comes back as a variation once the templater has been. Priced as fabrication, not as area. Send us the run lengths, plus photos taken walking from the pavement through the hall to the kitchen so we can see the door widths and the stair turn. Where ownership is split across a building, the common parts belong to someone else and the carry route is negotiated rather than assumed. Nothing is payable until we template, so a quote can sit while consents and decisions catch up. Written to be read by whoever is paying.