Worktop templating in Benhilton

Yes. Benhilton is on the patch, and the postcodes we work here are SM1. It is worked on our south London run, along with the rest of Sutton. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. The templating visit needs somewhere to stop for two or three hours, which is a different problem from unloading for twenty minutes. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The bay at the front and the back addition at the rear were built to different standards, and the kitchen is nearly always in the weaker of the two. Victorian party walls and chimney-breast returns bow along their length, so the template plots the real line rather than assuming a straight one - the template picks up points every few hundred millimetres down the back of the run and the drawing carries that curve through to the saw. Two to three hours, once the units are in. Boiler cupboards in the corner of these back additions are usually staying put, so we template around them and put the joint at the cupboard return.

Streets climb steeply from the town centre with parking on both sides and no off-street space on the terraces, so the carry is up a hill and then in through the front door. Door width, hall width and the diagonal at the turn are three separate measurements, and it is the diagonal that catches people out. Door widths, turn diagonals and any change of level are recorded on the drawing alongside the run dimensions. It goes on the drawing with the run dimensions.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. The template visit is booked once the units are genuinely in, not when they are nearly in. Units fitted, fixed and level first.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The template records every angle in that shape as it actually is rather than as the plan drew it. Real angles, not plan angles. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Boxing is rarely the same depth at worktop height as it is at floor level, so measuring it low down is the usual reason a top will not sit back. It is recorded on the drawing with the run dimensions so the workshop is not guessing. Plotted, not estimated. Units fixed and packed level over the sloping floor, walls replastered and dry at their final thickness (tiling and splashbacks go on after the worktop, never before), and the sink, tap and hob physically on site, with a Belfast sink built in and set at its finished height. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. Fitted, fixed and level, then we come.