Worktop fabrication in Sydenham

Yes. Sydenham is on the patch, and the postcodes we work here are SE26. It is worked on our south east London run, along with the rest of Lewisham. Underground loading has a height restriction, and a van with an A-frame on it is taller than the driver remembers. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. It is decided in the yard, not at the kerb. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Cornice, picture rails and deep skirting survive in converted rooms, so the run stands off the wall and the back edge follows the units rather than the plaster. The galley run down a side-return usually measures longer than a slab will give us, so a join is designed in from the start and nested to land over a cabinet gable rather than wherever the material happens to run out. The bench proves it before the van moves. Flat conversions above the shops are the awkward ones, a narrow stair straight off the street and no rear access at all.

The main road is busy with buses and loading restrictions, the residential streets climb steeply toward Sydenham Hill, and almost none of the terraces have off-street parking. Stone goes up on edge, and it is the half-landing turn rather than the flight itself that sets the maximum piece. So the nesting is worked to the measured route first and to the slab second. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop templating and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. So the nesting is planned around it rather than around a standard kitchen. Same slab run, or it is not a match. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch.

Because a peninsula is seen from both sides, the underside of any overhang gets the same edge treatment as the top, which is easy to leave out of a spec. A join that lands in the wrong place cannot be moved once the cut-outs are machined, so it is settled on the drawing. Every join sits over a gable. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Walls that bow along their length are the normal condition rather than the exception, and a straight-cut back edge will show a shadow gap at one end and touch at the other. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Machined to the real line. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. Dry-assembled before it leaves.