Worktop templating in Telegraph Hill

Yes. Telegraph Hill is on the patch, and the postcodes we work here are SE14. It is worked on our south east London run, along with the rest of Lewisham. Off-street parking means the van stays put all day, so tools, packers and the offcut we would rather have than not are all within reach. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. It goes on the job sheet for the fitting crew. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A range sitting in a chimney recess is common, and the flanking pieces are cut with the manufacturer clearance built into the template. One datum for the whole room, because a floor that falls end to end shows as a step between island and perimeter. Two to three hours, once the units are in. A dozen steps up from the pavement then a stair inside is the normal profile here, anything over 2.5m needs three people or a joint.

Some of the steepest streets in the borough, with houses set high above the pavement behind long flights of steps and railings; conservation-area frontages mean no dropped kerbs and permit-only parking. Weight tells on a staircase more than anywhere else, because there is nowhere to set a piece down mid-flight and no way to change your grip once it is moving. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. The template records it along with everything else.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop fabrication and worktop replacement. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. No stone is ever cut from a plan, which is inconvenient exactly when a programme is tight. The room as it is, not as it was drawn. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. The template visit is booked once the units are genuinely in, not when they are nearly in. Appliances on site, not on order.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Join positions and vein direction are marked on the template drawing before it leaves site. The drawing leaves site complete. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Floors settle, and once base units are packed and levelled properly the stone sits true while everything else in the room admits it is not. The template plots it as it is, at the exact height the worktop will sit, and the drawing carries that through. Measured at worktop height, nowhere else. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. The templater needs the sink, tap and hob on site, and a Belfast sink installed at its final height. No stone is cut from a plan.