Splashbacks and upstands in Telegraph Hill

Yes. Telegraph Hill is on the patch, and the postcodes we work here are SE14. It is worked on our south east London run, along with the rest of Lewisham. A front drive is the best thing that can happen to a fitting day, because the tail lift comes down within a few metres of the door and nothing is on a clock. Upstands travel in a crate and can wait on the van, which gives some flexibility a full-height panel does not. Handling is where these pieces get damaged. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Original walls are thick, lime-plastered and rarely straight, which makes dry-laying and scribing the bulk of the fitting day. Long runs mean more than one piece, and the joint belongs in a corner or on a hob centre line rather than mid-run. Decided before fabrication starts. A dozen steps up from the pavement then a stair inside is the normal profile here, anything over 2.5m needs three people or a joint.

Some of the steepest streets in the borough, with houses set high above the pavement behind long flights of steps and railings; conservation-area frontages mean no dropped kerbs and permit-only parking. Weight tells on a staircase more than anywhere else, because there is nowhere to set a piece down mid-flight and no way to change your grip once it is moving. Splashback panels are lighter than a worktop and far more awkward, because a tall thin piece has to be carried on edge and cannot be tilted to clear a turn. It decides panel size before anything is cut.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop fabrication and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. Ordered later from a different batch, the match is not reliable exactly where the pieces meet. Same batch, same run, same day. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Sockets final before template.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Long runs almost never take a single panel, so the joint positions want agreeing before anything is templated. Corners get their own pieces. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Level has to hold across the whole room rather than along one wall, or a floor that falls end to end shows as a step where two pieces meet. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. The range and extractor must be sited and the window cill finished before the template, as both fix the vertical limits of the splashback. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. A 100mm upstand is the low-maintenance answer, and full-height stone is the one that has to be committed to early. Decided before fabrication, not after.