Splashbacks and upstands in Tottenham Green

Yes. Tottenham Green is on the patch, and the postcodes we work here are N15, N17. It is worked on our north London run, along with the rest of Haringey. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A range sitting in a chimney recess is common, and the flanking pieces are cut with the manufacturer clearance built into the template. These runs are long and often include a range recess, so the splashback is nearly always more than one piece and the joint placement matters, put it in a corner or over a hob centre line, not randomly in the middle of a clear run. The wall makes that decision, not the brochure. Deep original skirtings mean the base units stand off the wall - either scribe the top back or set the units forward consistently, but decide before you template or the run steps.

The Green sits on the High Road with bus lanes and event closures, and several of the converted buildings are listed with restrictions on fixing into original fabric. Communal entrances with a keypad and a hall that must stay clear as a fire route. Estate roads are often too tight for a long-wheelbase van to turn, so the carry starts a good deal further from the door than a map suggests. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. Joint positions follow from that.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop installation and worktop replacement. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Siliconed to the worktop, never grouted.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Long runs almost never take a single panel, so the joint positions want agreeing before anything is templated. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. A tall panel that fits at the worktop will stand off the wall at the top unless the wall is dubbed out or the panel is scribed. An upstand rides what a panel exposes. The range and extractor must be sited and the window cill finished before the template, as both fix the vertical limits of the splashback. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. Full-height panels need the wall made good first, which is another trade and another timescale. Same slab run as the tops.