Worktop replacement in Tottenham Green

Yes. Tottenham Green is on the patch, and the postcodes we work here are N15, N17. It is worked on our north London run, along with the rest of Haringey. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. A replacement is a two-way job, with old tops going out and new stone coming in, so the van needs to stay put across the whole day. The waste run is planned, not improvised. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A large villa has wide doors, a generous hall and somewhere to park, so the joins that go in are chosen for layout rather than forced by the route. Any island overhang past about 300mm will not carry weight on the carcass alone, so flat steel bar or brackets have to be let into the units first, and that is agreed at template stage, not on fit day. What is under the old top is the real question. Deep original skirtings mean the base units stand off the wall - either scribe the top back or set the units forward consistently, but decide before you template or the run steps.

The Green sits on the High Road with bus lanes and event closures, and several of the converted buildings are listed with restrictions on fixing into original fabric. Communal entrances with a keypad and a hall that must stay clear as a fire route. Where the parking court sits behind the block the carry crosses open ground and gets boarded, because loaded trolleys and block paving do not agree. Worth remembering that the old tops have to come out the way the new ones come in, and a laminate run is easier to remove in one length than to carry in one. That is agreed before a plumber is booked.

It is one of the three we do most here, behind worktop templating. Same template visit, same workshop, same installers either way. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Old tops out in the morning, new stone down and sealed the same afternoon. A day, not a project.

The catch with a galley is that both runs are seen end-on from the doorway, so any difference in overhang between the two reads immediately. Old laminate has often been holding a run square for years, and taking it off shows what the units were really doing. Carcasses have to be sound first. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. This is the commonest reason a replacement turns out to need more than a straight swap. Found at template, not on fit day. Have a fitter or joiner fix and level the island units beforehand, and get the sink, taps, hob and any range on site before templating so we cut to the actual appliances. An owner living in the house makes the decisions and lives with them, so the specification tends to go towards the material rather than towards the lowest total. If the carcasses are tired the honest answer is that stone will find that out, and it is better said before than after. Units kept, surface changed.