Splashbacks and upstands in Tulse Hill

Yes. Tulse Hill is on the patch, and the postcodes we work here are SW2. It is worked on our south London run, along with the rest of Lambeth. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A range sitting in a chimney recess is common, and the flanking pieces are cut with the manufacturer clearance built into the template. These runs are long and often include a range recess, so the splashback is nearly always more than one piece and the joint placement matters, put it in a corner or over a hob centre line, not randomly in the middle of a clear run. Decided before fabrication starts. Upper-floor kitchens in converted villas mean everything is carried up two flights, so the piece count matters more than the piece size, keep the number of separate carries down.

The area is hilly with houses set above the road on stepped front gardens, so there is a climb before you reach the door and then two or three flights inside. Estate blocks have lifts but small cars, and the South Circular traffic dictates arrival timing. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. Joint positions follow from that.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop installation and worktop templating. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Siliconed to the worktop, never grouted.

Galley runs are usually short enough to come out of a single slab, so the material band you choose does more to the total than the room shape does. The same shape decides where splashback pieces break, and a joint in a corner reads as a detail while one in a clear run reads as a mistake. Joint placement is a decision, not an accident. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Window boards and cills stand proud of the plaster, so the back edge of the top has to be plotted to where the units actually sit rather than to the wall. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. The range and extractor must be sited and the window cill finished before the template, as both fix the vertical limits of the splashback. Owner-occupied kitchens are usually being done once, which is why the edge profile, the vein direction and where a join falls are worth the conversation. Full-height panels need the wall made good first, which is another trade and another timescale. Decided before fabrication, not after.