Splashbacks and upstands in Streatham Hill

Yes. Streatham Hill is on the patch, and the postcodes we work here are SW2. It is worked on our south London run, along with the rest of Lambeth. Loading exemptions on red routes are narrow, time-limited and heavily camera-enforced, so we plan around them rather than relying on them. Splashbacks are normally the last thing off, so a short parking window is exactly when they get rushed. One trip is always better than three. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

The lift is a small passenger car with a gate, and the alternative is a stone stair winding round the shaft with a turn at every half-landing. Each return needs its own piece with a mitred or butted external corner, and those pieces should come off the same slab so the movement lines up across the corner. Cut from the same slab run as the tops. The 1930s galley kitchens are barely 1.8m wide, which means a standard 600mm top plus an opposite run leaves under 600mm of walking space, check the client actually wants both sides before fabricating.

Several of the blocks are listed or in a conservation area, so no fixings to communal fabric and no propping doors open; lifts are original and small. The A23 is a red route with no stopping, so unloading happens on side roads and the carry starts from there. Where the lift will not take the longest run we design a join in rather than gamble, because a piece that will not go up has to go back on the van. It is usually the full-height panels rather than the tops that will not make the turn, and that only shows up when they arrive. It decides panel size before anything is cut.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. Socket and switch positions have to be final before templating, because a cut-out in the wrong place means a new piece. Sockets final before template. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. Splashbacks and upstands are cut from the same slab run at the same time, which is the only way the batch actually matches. Same batch, same run, same day.

A galley puts the sink on one side and the hob on the other, which spreads the cut-outs across two pieces instead of weakening one. Upstands follow the run exactly, so every internal and external corner is a separate mitred or butted piece. Corners get their own pieces. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A boxed soil stack or service riser in the corner of a run eats into the worktop depth and has to be scribed around rather than cut square. It is usually what pushes a job towards a 100mm upstand instead of a full-height panel, because an upstand rides what a panel exposes. An upstand rides what a panel exposes. The riser boxing must be finished in its final form and any access panel positions agreed before the template, since the stone is set out around them. The same building type can arrive as a careful one-off kitchen or as a fast turnaround, and the honest answer is that they are priced differently. Splashbacks are cut from the same slab run as the tops, so they have to be decided before fabrication, not after. Decided before fabrication, not after.