Worktop templating in Streatham Hill

Yes. Streatham Hill is on the patch, and the postcodes we work here are SW2. It is worked on our south London run, along with the rest of Lambeth. The realistic answer on a main road is an early slot, a spotter on the van and pieces staged in one movement rather than several trips. A templater circling for a space arrives late into a slot that was already tight, and the drawing is what suffers. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These kitchens are full of boxed soil stacks, gas risers and heating pipework, and the boxing usually stops short of the ceiling. Boxing depth is taken at worktop height at several points, because measuring it low down is why a top will not sit back. Recorded as it is, not as it was drawn. The 1930s galley kitchens are barely 1.8m wide, which means a standard 600mm top plus an opposite run leaves under 600mm of walking space, check the client actually wants both sides before fabricating.

Several of the blocks are listed or in a conservation area, so no fixings to communal fabric and no propping doors open; lifts are original and small. The A23 is a red route with no stopping, so unloading happens on side roads and the carry starts from there. The lift has to be booked and blanketed before anything moves, and that booking needs to cover the old tops coming out as well as the new stone going in. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

It is one of the three we do most here, behind worktop replacement. Same template visit, same workshop, same installers either way. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. The template visit is booked once the units are genuinely in, not when they are nearly in. The room as it is, not as it was drawn.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. A layout templated off one wall instead of one datum will not sit right once all the pieces are down together. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Anything that has to stay accessible, a stopcock, a gas meter, a riser panel, is marked on the template so the stone is cut around it instead of over it. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. Plotted, not estimated. Boxing and riser casings built, cased and finished to their final surface, units fixed and levelled, and building access, lift booking and porter arrangements agreed so both the template visit and the later fit can run. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The template happens when the units are in, fixed and level, whoever is fitting them. Fitted, fixed and level, then we come.