Worktop templating in Upper Norwood

Yes. Upper Norwood is on the patch, and the postcodes we work here are SE19. It is worked on our south London run, along with the rest of Croydon. Unrestricted kerbside is straightforward as long as the space in front of the property is actually clear when the van arrives. It is noted on the job sheet at template so the fitting crew inherit the answer rather than rediscovering it. The templater needs a proper stop, not a pause. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These kitchens are big rooms with long perimeter runs and an island, so level has to hold across the whole floor rather than along one wall. Long perimeter runs and an island mean level has to hold across the whole room, so the templater sets a single datum and works every run and the island off it rather than levelling each wall in isolation. Recorded as it is, not as it was drawn. Low ceilings in lower ground floor kitchens mean you cannot tilt a long piece to get it round a corner, so anything over 2.4m gets a designed joint before it leaves the shop.

The steepest streets in the borough, with houses set well above or below road level and long flights of front steps. Lower ground floor kitchens mean carrying stone down as well as along. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. The templater measures that route on the same visit, so the drawing leaves site already knowing the maximum piece. It goes on the drawing with the run dimensions.

Yes. On the research for this patch it is the first of the three jobs listed, ahead of worktop fabrication and worktop installation. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Two to three hours on site, with the sink, tap and hob physically present. Appliances on site, not on order.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. The template records every angle in that shape as it actually is rather than as the plan drew it. One datum for the whole room. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Window boards and cills stand proud of the plaster, so the back edge of the top has to be plotted to where the units actually sit rather than to the wall. One measurement never describes it, which is why a tape reading taken before the visit rarely matches the template. That is why the visit takes two or three hours. All runs and the island carcass fixed down and levelled to one datum, with the sink, tap and hob on site - an island cannot be templated while it is still loose or sitting on packers. The householder is normally on site at template, and that is the right time to settle sink position, tap centres and overhang rather than agree them by email. A template booked hopefully around another trade is the commonest cause of a wasted visit. Fitted, fixed and level, then we come.