Worktop fabrication in Upper Norwood

Yes. Upper Norwood is on the patch, and the postcodes we work here are SE19. It is worked on our south London run, along with the rest of Croydon. Where the van can pull up level with the gate the pieces are handled the fewest times, which is what actually protects them. It rarely changes what we cut, but it does change how the pieces are stacked and strapped for the run out. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

A large villa has wide doors, a generous hall and somewhere to park, so the joins that go in are chosen for layout rather than forced by the route. Access is off a drive and through wide doors, so for once the piece size is not the constraint - the joins that go in are the ones we choose for layout and veining, not the ones the building forces. Settled on the drawing, cut once. Low ceilings in lower ground floor kitchens mean you cannot tilt a long piece to get it round a corner, so anything over 2.4m gets a designed joint before it leaves the shop.

The steepest streets in the borough, with houses set well above or below road level and long flights of front steps. Lower ground floor kitchens mean carrying stone down as well as along. A narrow entrance hall with a turn into the back of the house caps the longest piece we can physically get in, whatever the run itself measures. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. It is settled on the bench, not on site.

It is one of the three we do most here, behind worktop templating. Same template visit, same workshop, same installers either way. Party-wall and lease conditions in a converted building set when noisy work can happen, which shapes the fitting day more than the kitchen does. Pieces are dry-assembled and checked on the bench before anything is loaded. Same slab run, or it is not a match. Conversions put kitchens where the services could be made to reach rather than where they belong, so runs are short and interrupted. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Proven on the bench before dispatch.

An island is a single visible piece with four finished edges and no wall to hide against, so it is the piece the whole kitchen is judged on. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

A low sill over the sink run is what decides between an upstand and stone dying into a window board, and there is often less clearance than an upstand is tall. The template drawing carries the real geometry through to the saw, and the piece is machined to it rather than trimmed to it later. Radiused, polished, and clear of the joins. The range or Aga, the sink and the tap all need to be confirmed by model before nesting, because their clearances and hole positions set where the island can be cut. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. Changing an appliance after the nest is set means recutting the piece, not adjusting it. Changes cost a piece, not a tweak.