Worktop fabrication in Norbury

Yes. Norbury is on the patch, and the postcodes we work here are SW16. It is worked on our south London run, along with the rest of Croydon. A drive that shelves towards the house needs the van chocked and the trolley controlled, since a loaded A-frame gathers speed quickly on a slope. Where unloading has to happen in one go, the load order is planned so nothing has to come off twice. The load plan follows from it. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

Where the side return has been filled in, the old external wall is now an internal one and still carries its render, its gutter line and its old fixings. The galley run down a side-return usually measures longer than a slab will give us, so a join is designed in from the start and nested to land over a cabinet gable rather than wherever the material happens to run out. Settled on the drawing, cut once. Anything on the London Road frontage has to be unloaded outside restricted hours, so we book those fits first thing rather than mid-morning.

London Road has red route restrictions through the day, so timing matters; the residential roads climbing east are steep with parking on both sides and short driveways. A short hard approach with no steps means a full-length piece can be walked in flat by two people rather than turned up on edge. The maximum piece length is fixed at drawing stage and every join is placed over a cabinet gable from there. The drawing carries that decision through to the saw.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop replacement, worktop splashbacks & upstands and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. Rear and side-return extensions are where the islands appear, and an island is the piece that decides whether one slab does the kitchen or two. Cutting several kitchens from different slabs and calling them matched is where firms get caught out. Same slab run, or it is not a match. A new extension slab is not automatically level, and that wants checking before templating rather than after the stone is cut. So the nesting is planned around it rather than around a standard kitchen. Proven on the bench before dispatch.

Two parallel runs with a walkway between them is the most efficient shape there is on a slab, because both pieces nest as straight lengths with almost no waste. The nest is laid out around that, with joins placed over cabinet gables and kept clear of every cut-out. The bench proves it before the van does. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a corner is a couple of degrees off, a mitre cut to a theoretical ninety degrees opens on the wall side and there is no closing it afterwards. Cut it square where it should be radiused and the piece will fail on the lift, not in the kitchen. Machined to the real line. The sink and hob need to be on site and the run layout fixed before we start cutting, because moving a hob after the join position is set means recutting the whole piece. Mixed ownership means the decision-maker is not always the person who lets us in, so it is worth being clear early about who signs the quote off. The workshop works from the approved drawing, so whoever signs it off is signing off the join positions too. The approved drawing is the instruction.