Worktop replacement in Upper Norwood

Yes. Upper Norwood is on the patch, and the postcodes we work here are SE19. It is worked on our south London run, along with the rest of Croydon. On a street with no restrictions the constraint is other residents rather than a warden, so it is worth putting a cone or a car out early. Waste is the part people forget: the old laminate or tired granite has to be walked back to the van and it does not get lighter. The waste run is planned, not improvised. We template in your kitchen and fit in your kitchen, so there is nothing to visit and nothing to collect.

These kitchens are big rooms with long perimeter runs and an island, so level has to hold across the whole floor rather than along one wall. Any island overhang past about 300mm will not carry weight on the carcass alone, so flat steel bar or brackets have to be let into the units first, and that is agreed at template stage, not on fit day. Sound carcasses are the one condition. Low ceilings in lower ground floor kitchens mean you cannot tilt a long piece to get it round a corner, so anything over 2.4m gets a designed joint before it leaves the shop.

The steepest streets in the borough, with houses set well above or below road level and long flights of front steps. Lower ground floor kitchens mean carrying stone down as well as along. Everything comes through the front door and down the hall, so the tightest point on the route is usually the newel post at the foot of the stairs. We plan the strip-out and the carry as one movement so the kitchen is only out of use for a single day. The strip-out is planned around it.

Not particularly, and it would be easy to pretend otherwise. What the research on this patch actually lists is worktop templating, worktop fabrication and worktop installation. That is a statement about the local housing rather than about the work. It is quoted, cut and fitted exactly the same way here as anywhere else on the patch. In a converted house the flat entrance and the internal doorway are usually tighter than the communal stairs, and that is easy to overlook. The units stay and only the surface changes, so the whole job is one day rather than a kitchen refit. Sound carcasses or it does not go ahead. A kitchen carved out of a larger room sits under whatever the original plan left behind, so the run frequently ends at a blocked doorway or a boxed-in service. The carcasses have to be sound, because stone is several times the weight of what is coming off. A day, not a project.

If the island is a few hundred millimetres longer than the usable length of a slab, a second slab gets bought to gain that overhang, and the whole slab is paid for rather than the part used. Old laminate has often been holding a run square for years, and taking it off shows what the units were really doing. Height change is checked before we cut. Material is £110-£550 per square metre supply only, and templating, fabrication and fitting are quoted on their own lines.

Where a run finishes into a reveal, the depth of that reveal is taken at worktop height and nowhere else. The old top has been hiding it, so the first honest look at it happens when the laminate comes off. Found at template, not on fit day. Have a fitter or joiner fix and level the island units beforehand, and get the sink, taps, hob and any range on site before templating so we cut to the actual appliances. Where someone is living in the house through the work, the strip-out and the fit are planned so the kitchen is out of use for a day and not a week. A replacement keeps the units and changes the surface, which is the least disruptive way to do this in an occupied property. Units kept, surface changed.